240 Degree

Tags

Ziegler DSL Analog 240° Panel Ammeter/Voltmeter

Analog 240° Panel Ammeter/Voltmeter , DSL 48/72/96,144 housed in moulded polycarbonate cases are suitable for the measurement of DC currents and voltages . These instruments offer several advantages in switchboard and Generating Set Panels .

View Details

analog Ammeter

Analog 240° Panel Ammeter/Voltmeter , DGL 48/72/96,144 housed in moulded polycarbonate cases are suitable for the measurement of AC currents and voltages. These instruments offer several advantages in switchboard and Generating Set Panels . measure average values & are calibrated to indicate RMS values, assuming a sinusoidal waveform for frequencies from 40 to 10000 Hz (AC current - 40 to 1000 Hz and AC voltage - 40 to 10000 Hz)

View Details

Frequency Meter

The pointer type frequency meters , FML 96 and FML 144 housed in moulded polycarbonate cases are used for the measurement of frequencies in the range of 45 to 450 Hz . These instruments offer several advantages in switchboards and Generating Set Panels .

View Details

Analog panel wattmeter/varmetter

The Watt and Var meters , LML are offered for the following AC systems , single phase , 3 phase balanced load 3 or 4 wire , 3 phase unbalanced load 3 or 4 wire . LML 96 | 144 housed in moulded polycarbonate cases are suitable for the measurement of active and reactive power . They can be used both on sinusoidal and non-sinusoidal current .

View Details

Panel Power factor meter

LFL Analog 240° Panel Power factor meter is indirectly determined by measuring the phase angle between current and voltage (both sinusoidal) . suitable for power factor changes. The meter in sizes 72, 96 and 144 have been produced in the form of polycarbonate .

View Details

Measuring Instrument

Measuring Instruments are applicable for measurement and monitoring the quantities such as voltage, current, active power, reactive power, frequency, power factor, temp, humidity and etc.

View Details

Analog Panel Meter

Analog Panel Meter are used for reading values of AC and DC current, voltage, frequency, Watt, Var, cosine phi (power factor). The meter is available in needle deviation of 90 degrees and 240 degrees. and also temperature meter are custom available.

View Details

Analog meters Accessories

Variations in scales and using location of analog meter make necessary using accessories. Using accessories able the analog meter to have more versatility with conditions.

View Details

DC Signal Meter

The moving coil meters are applied to measure low power DC signals, for example 0 to 1 mA/4 to 20 mA/0 to 10V DC etc. DQ is available in four different sizes, in other words 48 mm, 72 mm, 96 mm and 144 mm.

View Details

Watt and VAr meter

The WQ measures power or reactive power using a moving coil movement and a built-in electronic Watt or VAr transducer. Measuring power in a single-phase or 3-phase network, the transducer P.C.B. converts the signal into a DC current which is then fed to the moving coil instrument.

View Details

Power factor meter

The PFQ power factor meter measures cos phi with a moving coil movement and an electronic transducer. The transducer measures the phase angle between an AC voltage and the corresponding AC current, converting the signal into a proportional DC current which is then fed to the moving coil instrument.

View Details

Zero Voltage Meter

The zero voltage meter type NEQ is a moving iron instrument calibrated to full scale deflection at twice the nominal mains voltage, whereas 2/3 deflection corresponds to nominal mains voltage. Because of the expanded scale graduation within the range 0...0.5 of full scale, the NEQ is highly applicable to supervise the synchronisation of a generator to the busbar.

View Details