The SR11 system is destined for the temperature control in injection moulds with heated channels and for other systems in plastics processing.
• Complete set for temperature control in injection moulds with heated channels.
• System equipped with 1 or up to 8 controllers in one housing (depending on the version).
• Built-in 15 A SSR output for each control zone (output resolution: 0.1 A).
• PID control with auto tuning and Fuzzy logic algorithm ensuring a high temperature control accuracy and optimal energy consumption.
• “Soft start” function enables the mould preheating.
• Monitoring of the leakage current of heater.
• Signalling of breaks, short-circuits and inverse polarization of the sensor.
• Measurement of the heater leakage current and detect on of the maximal current exceeding.
• Measurement of the load current, detection and damage signalling.
• Emergency work mode after the thermocouple damage with a mean power delivered before the damage with a mean power delivered before the damage or with the output turned oﬀ .
• RS-485 interface with MODBUS protocol (ASCII and RTU modes) for connection with PC, recorders or other Modbus devices.
• Decreased temperature mode (remote activation with logic input or local activation using the buttons).
• Relay output to signal the alarm states.
Borna Niroo Karan (Bornika) is the exclusive agent of LUMEL in the fields of consultation , sales and distribution of power industry products including Injection Moulds Controller products .
SSR relay 15 A, 230 V a.c./ heating zone up to 8 control outputs
voltageless relay : 1 A maximum 50 V a.c./d.c., NO contact , signaling of control deviation overﬂow
1 zone system: 230 V a.c. +/- 10%
2 .. 8 zone system: 3 x 230/ 400 V a.c. +/- 10%
SR11-1XXXX : 200x77.5x355 mm
R11-3XXXX : 197x215x355 mm
SR11-6XXXX : 197x365x355 mm
SR11-8XXXX : 197x465x355 mm
Ordering Code SR11-a b c d e :
a: Housing dimensions:
housing width 77.5 mm , number of controllers: 1 : 1
housing width 215 mm number of controllers: 2, 3 : 3
housing width 365 mm number of controllers: 4, 5, 6 : 6
housing width 465 mm number of controllers: 7, 8 : 8
b: Number of controllers:
1 controller : 1
2 controllers : 2
3 controllers : 3
4 controllers : 4
5 controllers : 5
6 controllers : 6
7 controllers : 7
8 controllers : 8
c: RS-485 interface:
without RS-485 interface : 0
with RS-485 interface : 1
d: Connection for moulds:
common connectors for thermocouples and heaters : 1
separate connectors for thermocouples and heaters : 2
e: Acceptance tests:
without extra quality requirements : 0
with an extra quality inspect on certiﬁcate : 1